Microcosm M11 Electric Steam boiler feed pump

Microcosm  M11  Electric Steam boiler feed pump 
Planetary reduction gearbox is a high-grade structure for two deceleration, the first stage sun gear is nylon wheel, reducing noise with the other gears  are all steel gears in the gearbox are lubricants. Planetary gear structure is the advantage ofCompact, small backlash, high accuracy, high transfer   efficiency, long life, rated output torque.
Planetary gearbox gear motor, coil resistance 8 ohms.
Motor shaft diameter 24MM 55MM long milling flat 4MM D-shaped shaft length 16MM

The motor operating voltage from 3V to 24V

3V No load speed 80 torque 0.3KG.CM

6V No-load speed 200 rpm torque 1KG.CM

12V No-load speed 400 rpm torque 2KG.CM

24V No-load speed of 800 rpm torque 4KG.CM

The feed water pump is used to supply the boiler with fresh water.

The feed water pump is a very visually appealing extension for each steam plant and also significantly increased the functionality.

This feed water pump works by two check valves positioned one behind the other.

By pulling back the plunger is formed in the pump housing, a negative pressure so that the upper non-return valve closes and the fresh water is drawn into the pump at the bottom inside.

When the plunger is moved forward again due to excessive pressure in the interior.

The lower check valve closes and the pressure can only upwardly through the

the boiler is connected to the escape.

The eccentric is clamped with a set screw on the drive shaft. Water supply connector 360 installed.

Products: copper and stainless steel, long 55MM, width 30mm, high 42mm, bore 6MM, piston stroke 5MM, eccentric 15MM, shaft hole 4mm,Side of the hole thread: M3 with the top wire Specifications.

When the working pressure 5V power, his maximum output pressure of about 6 kg,about 85PSI.

When the operating voltage is 5V, the output flow rate of about 270 ml per hour.Thank you.

http://youtu.be/9RaHaLm98go